Fluidized Bed Combustion: Technology for Efficient Utilization of Biomass Residues

Authors

  • Vishal Sharma Department of Mechanical Engineering, Chitkara University Institute of Engineering & Technology, Rajpura, Punjab, India
  • Rajeev Kamal Sharma Department of Mechanical Engineering, Chitkara University Institute of Engineering & Technology, Rajpura, Punjab, India

DOI:

https://doi.org/10.51983/ajeat-2018.7.2.951

Keywords:

Biomass, Fluidized Bed Combustion, Biomass Utilization Technologies

Abstract

Fossil fuels are the most common and reliable energy source, which presently fulfill 80% energy requirements all across the world. In the last few decades, over-consumption, fast pace modernization and population growth are some prominent factors which are exploiting the fossil fuels. The degradation of natural resources has gone up at an alarming rate which provoked to look for an alternate source of energy. From all available alternative renewable energy sources, biomass is the only carbon-based sustainable option. But, its diversity makes it a complex and difficult fuel. Among all technologies used for energy generation from the biomass, fluidized bed combustion is emerging as a suitable best option to handle fuel diversity. This article deals with biomass fluidization and its combustion in a fluidized bed. The difficulties encountered during biomass combustion and different solutions for the same have been highlighted. Problems like deposition, corrosion, agglomeration and trace metal emission have been discussed and their remedies to avoid the discontinuity in the operation of biomass-fired fluidized bed combustor. This technical approach will help to reduce environmental problems, improve the economic structure of the nation, and remove obstacles for sustainable energy development.

References

British Petroleum, "BP Statistical Review of World Energy 2007," June, pp. 1–48, 2007.

Annual BP Report, "Our key priorities Safety People Performance," Rev. Lit. Arts Am., 2007.

U.S. Energy Information Administration, "International Energy Outlook 2017," Int. Energy Outlook, vol. IEO2017, pp. 143, 2017.

B. K. Sovacool, R. J. Heffron, D. McCauley, and A. Goldthau, "Energy decisions reframed as justice and ethical concerns," Nat. Energy, vol. 1, pp. 16-24, 2016.

C. Vernon and E. Thompson, "Carbon dioxide emission scenarios: limitations of the fossil fuel resource," Procedia Environ. Sci., vol. 6, pp. 206–215, 2011.

S. Shafiee and E. Topal, "When will fossil fuel reserves be diminished?," Energy Policy, vol. 37, no. 1, pp. 181–189, 2009.

J. Popp, Z. Lakner, M. Harangi-Rákos, and M. Fári, "The effect of bioenergy expansion: Food, energy, and environment," Renew. Sustain. Energy Rev., vol. 32, pp. 559–578, 2014.

M. H. Ramage, "The wood from the trees: The use of timber in construction," Renew. Sustain. Energy Rev., vol. 68, pp. 333–359, 2017.

G. S. Alemán-Nava, "Renewable energy research progress in Mexico: A review," Renew. Sustain. Energy Rev., vol. 32, pp. 140–153, 2014.

J. Ministry of Agriculture, Forestry, and Fisheries, "The Asian Biomass Handbook Support Project for Building Asian-Partnership for," Japan Inst. Energy, pp. 338, 2008.

N. L. Panwar and N. S. Rathore, "Potential of surplus biomass gasifier based power generation: A case study of an Indian state Rajasthan," Mitig. Adapt. Strateg. Glob. Chang., vol. 14, no. 8, pp. 711–720, 2009.

M. F. Demirbas, M. Balat, and H. Balat, "Potential contribution of biomass to the sustainable energy development," Energy Convers. Manag., vol. 50, no. 7, pp. 1746–1760, 2009.

Ministry of New and Renewable Energy, "No Title." [Online]. Available: https://mnre.gov.in/file-manager/annual-report/2015-2016/EN/Chapter 1/chapter_1.html.

"MNRE." [Online]. Available: https://web.archive.org/web/20180503151432/http://mnre.gov.in/physical-progress-achievements.

A. A. Khan, W. de Jong, P. J. Jansens, and H. Spliethoff, "Biomass combustion in fluidized bed boilers: Potential problems and remedies," Fuel Process. Technol., vol. 90, no. 1, pp. 21–50, 2009.

"ORC-main".

G. H. Williams, "Fuel from biomass," Chem. Eng. News, vol. 70, no. 47, pp. 3–3, 1992.

T. R. M. B. M. Jenkins, L. L. Baxter, and T. R. Miles Jr., "Combustion properties of biomass," Fuel Process. Technol., vol. 54, no. 1–3, pp. 17–46, 1998.

H. Eet-kb, R. Energy, U. Technologies, and B. Energy, "Biomass," 2018, pp. 7–8.

D. Ouwens, "Gasification of biomass and residues for electricity production Pergamon," 1997.

R. Van den Broek, A. Faaij, and A. van Wijk, "Biomass combustion for power generation," Biomass and Bioenergy, vol. 11, no. 4, pp. 271–281, 1996.

J. Y. T. Lipsanen, T. N. H. Räikkönen, and O. Antikainen, "Particle Size, Moisture, and Fluidization Variations Described by Indirect In- line Physical Measurements of Fluid Bed Granulation," AAPS PharmSciTech, vol. 9, no. 4, pp. 1070–1077, 2008.

H. Kassman, "Strategies to Reduce Gaseous KCl and Chlorine in Deposits during Combustion of Biomass in Fluidised Bed Boilers," Ph.D., 2012.

S. Suranani and V. R. Goli, "Fuel Particle Size Effect on Performance of Fluidized Bed Combustor Firing Ground Nutshells," Int. J. Chem. Eng., pp. 147–151, 2016.

H. P. Nielsen, F. J. Frandsen, K. Dam-Johnson, and L. L. Baxter, "The implications of chlorine-associated corrosion on the operation of biomass-fired boilers," Progress in Energy and Combustion Science, vol. 26, pp. 283-298, 2000.

L. L. Baxter, "Influence of ash deposit chemistry and structure on physical and transport properties," Fuel Processing Technology, vol. 56, no. 1-2, pp. 81-88, 1998.

L. L. Baxter, B. M. Jenkins, T. R. Miles, D. Dayton, "The behavior of the inorganic material in biomass-fired power boiler: field and laboratory experiences," Fuel Processing Technology, vol. 54, no. 1-3, pp. 47-78, 1998.

T. R. Miles, L. L. Baxter, R. W. Bryers, B. M. Jenkins, L. L. Oden, "Boiler deposits from firing biomass fuels," Biomass and Bioenergy, vol. 10, pp. 125-138, 1996.

J. Stringer and A. J. Minchiner, "High temperature corrosion in fluidized bed combustion system," Journal of Metals, vol. 36, no. 7, pp. 20-21, 1994.

I. Obernberger, "Concentrations of inorganic elements in biomass fuels and recovery in the different ash fractions," Biomass and Bioenergy, vol. 36, no. 6, pp. 410, 1997.

L. M. Romeo, R. Gareta, "Hybrid System for fouling control in biomass boilers," Eng Appl Artif Intell., vol. 19, no. 9, pp. 15–25, 2006.

L. M. Romeo and R. Gareta, "Fouling control in biomass boilers," Biomass and Bioenergy, vol. 33, no. 8, pp. 854–61, 2009.

R. R. Bakker, "Biomass fuel leaching for the control of fouling, slagging, and agglomeration in biomass power generation," Ph.D. Thesis, University of California, 2000.

V. Barisic, L. Amand, C. E. Zabetta, "The role of limestone in preventing agglomeration and slagging during CFB combustion of high-phosphorous fuels," [Online]. Available: http://fwcparts.com/publications/techpapers/files/TPCFB0803.pdf; 2008 [Accessed 10.07.18].

R. W. Bryers, "Fireside slagging, fouling and high-temperature corrosion of heat transfer surface due to impurities in steam raising fuels," Progress in Energy and Combustion Science, vol. 22, pp. 29-120, 1996.

W. Lin, K. Dam-Johansen, F. Frandsen, "Agglomeration in bio-fuel fired fluidized bed combustion," Chemical Engineering Journal, vol. 96, pp. 171–185, 2003.

M. J. F. Llorente, J. M. M. Laplaza, R. E. Cuadrado, J. E. C. Garcia, "Ash behaviour of lignocellulosic biomass in bubbling fluidized bed combustion," Fuel, vol. 85, pp. 1157–1165, 2006.

B. M. Jenkins, L. L. Baxter, T. R. Miles Jr., L. L. Oden, R. W. Bryers, "Composition of ash deposits in biomass fueled boilers: results of full scale experiments and laboratory simulations," in International ASME Summer Meeting, Kansas City, USA, pp. 19–24, 1994.

B. Olanders and B. M. Steenari, "Characterization of ashes from wood and straw," Biomass and Bioenergy, vol. 8, pp. 105–115, 1995.

J. Silvennoinen, "A new method to inhibit bed agglomeration problems in fluidized bed boilers," in FBC 2003, 17th International Fluidized Bed Combustion Conference, Florida, USA, pp. 1–9, 2003.

J. Daavitsainen, R. Laitinen, L. Nuutinen, H. Ollila, M. Tiainen, M. Virtanen, "Effect of GR GRANULE used as bed material to reduce agglomeration in BFB combustion of biomass with high alkali metal content," in Progress in Thermochemical Biomass Conversion, pp. 705–712, 2001.

R. Laitinen, L. Nuutinen, M. Tiainen, M. Virtanen, "An improved bed material for BFB boilers, Case 2: combustion of fuel with high sodium content," in 5th European Conference on Industrial Furnaces and Boilers, Porto, Portugal, pp. 1–6, 2000.

T. Lind, T. Valmari, E. I. Kauppinen, G. Sfiris, K. Nilsson, W. Maenhaut, "Volatilization of the heavy metals during circulating fluidized bed combustion of forest residue," Environmental Science & Technology, vol. 33, no. 3, pp. 496–502 , 1999.

M. Uberoi and F. Shadman, "Aluminosilicates as potential sorbents for controlling metal emissions," in ACS Symposium, vol. 515, pp. 214-222, 1993.

Downloads

Published

06-11-2018

How to Cite

Sharma, V., & Sharma, R. K. (2018). Fluidized Bed Combustion: Technology for Efficient Utilization of Biomass Residues. Asian Journal of Engineering and Applied Technology, 7(S2), 73–79. https://doi.org/10.51983/ajeat-2018.7.2.951