Necessity of DC Voltage Storage for Dynamic Voltage Restorer

Authors

  • Swapnil R. Borakhade Department of Electrical Engineering, Government College of Engineering Aurangabad. Aurangabad - 431 005. Maharastra, India
  • Anjali .U. Jawadekar Department of Electrical Engineering, Shri Sant Gajanan Maharaj College of Engineering, Shegaon - 444 203, Maharastra, India

DOI:

https://doi.org/10.51983/ajes-2012.1.1.1654

Keywords:

DVR, Power Quality, Voltage Sags, Voltage Source Inverter

Abstract

Problems of voltage sags and swells and its severe impact on sensitive load is well known. To solve the problems custom power devices are used, one of those devices is DVR which is most efficient and effective modern custom power device used in power distribution network. DVR is a very effective series-compensation device for mitigating voltage sags. The mitigation capability of these devices is mainly limited by the energy storage capacity. This paper presents the application of DVR on power distribution systems for mitigation of voltage sag and swell. An adequate modeling and simulation of DVR, including controls in MATLAB, shows the flexibility and easiness of MATLAB environment in analyzing such compensating devices. DVR which is based on forced commutated voltage source converter has been proved suitable for the task of compensating voltage sags and swells. Simulation results are presented to illustrate and understand the performance of DVR in supporting load voltage under voltage sag or swell conditions and also to assimilate voltage capacity of DC storage unit of a DVR with transmission voltage, by considering various factors.

References

C. Zhan, M. Barnes, V.K. Ramachandaramurthy, and N. Jenkis, “Dynamic Voltage Restorer with Battery Energy Storage for Voltage Dip Mitigation”, Power Electronics and Variable Speed Drives, pp. 18-19.

Francisco Jurado, Manul Valverde, and Jose Carpio, “Voltage Sag Correction by Dynamic Voltage Restorer Based on Fuggy Logic Control”, IEEE 2003.

Kasuni Perera, Daniel Salomon Son, Arulampaiam, Atputharajah, and Sanath Alahakoon, “Automated Control Technique for A Single Phase Dynamic Voltage Restorer”, IEEE, 2006.

S. V. Ravi Kumar, and S. Siva Nagaraju, “Simulation of D-Statcom and DVR in Power Systems” ARPN Journal of Engineering and Applied Sciences, Vol. 2, No. 3, June 2007.

Changjian Zhan,V.K. Ramachandrara Murthy, A. Arulampalam, M.Barnes, G.Strbac, and N.Jekin, “Dynamic Voltage Restorer Based on Voltage Space Vector PWM Control”, IEEE 2001.

M. R. Banaei, S. H. Hosseini, and M. Daekalee Khajee, “Mitigation of Voltage Sag Using Adaptive Neural Network with Dynamic Voltage Restorer”, IEEE 2006.

D. Mahinda Vilathgamuwa, H. M. Wijekoon, and S.S. Choi, “Interline Dynamic Voltage Restorer: A Novel and Economical Approach for Multiline Power Quality Compensation” IEEE, 2004.

Ali O Al-Mathunani, Azah Mohamed, and Mohd Alauddin Mohd Ali, “Photovoltaic Based Dynamic Voltage Restorer for Voltage Sag Mitigation”, IEEE 2007.

B. H. Li, S. S. Choi, and D. M. Vilathgamuwa, “Design Consideration on the Line –Side Filter Used In The Dynamic Voltage Restorer”, IEE 2001.

Downloads

Published

05-05-2012

How to Cite

Borakhade, S. R., & Jawadekar, A. .U. (2012). Necessity of DC Voltage Storage for Dynamic Voltage Restorer. Asian Journal of Electrical Sciences, 1(1), 17–22. https://doi.org/10.51983/ajes-2012.1.1.1654

Issue

Vol. 1 No. 1 (2012): January-June 2012

Section

Articles

License

Copyright (c) 2012 The Research Publication

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.